NARDA PMM CA0010, Руководство пользователя, Страница: 25 / 74

Setup and Panel Instructions 3-1
3 – Stand alone usage
3.1 Introduction The CLICK mode allows the User to make in a fast, easy and fully
automatic way a complex test like the Discontinuous Disturbances
measurement, as defined by current CISPR standards.
3.2 Click Mode
Activation
Procedure
The Click mode is an optional function for the 9010F EMI Receiver that can
be purchased separately.
To enable the Click mode use the 9010 Set code Utility
For further information on software installation and activation, please
refer to the 9010F User’s Manual.
Click activation confirm
Fig. 3-1 Click Mode
When the Click option has been successfully activated, the 4
th
menu button
appears as indicated in the picture above.
3.3 Enter the Click Mode
To enter Click Mode , press the corresponding key in the main menu, and
immediately the first window opens as following:
PMM CA0010 support requires 9010F firmware version 1.64 or later.
Updated firmware and software releases can be freely downloaded
from the official narda website at http://www.narda-sts.it
3.4 Preparing the
Hardware With the units switched OFF, connect PMM CA0010 RS232 port to PMM
9010F RS232 port, using the DB9-male to DB9-male supplied cable.
The RS232 port connectors are located on the rear panels of the two
instruments.
Connect also the RF Output of the PMM CA0010 to the RF Input of the
PMM 9010F, through the supplied short BNC coaxial cable.
Then, switch ON the PMM CA0010, and after a short time switch ON also
the PMM 9010F.
Document CA0010EN-80502-1.01 - © NARDA 2018