21
W415-0434 / C / 03.24.05
A.
This fireplace is equipped with a pilot which must be
lit by hand while following these instructions exactly.
B.
Before operating smell all around the fireplace area for
gas and next to the floor because some gas is heavier
than air and will settle on the floor.
C.
Use only your hand to turn the gas control knob. Never
use tools. If the knob will not turn by hand, do not try to
repair it. Call a qualified service technician. Force or
attempted repair may result in a fire or explosion.
D.
Do not use this fireplace if any part has been under
water. Immediately call a qualified service technician to
inspect the fireplace and replace any part of the control
system and any gas control which has been under wa-
ter.
GAS KNOB
When lit for the first time, the fireplace will emit a slight
odour for a few hours. This is a normal temporary condi-
tion caused by the curing of the logs and the "burn-in" of
internal paints and lubricants used in the manufacturing
process and will not occur again. Simply open a window to
sufficiently ventilate the room.
After extended periods of non-operation such as following
a vacation or a warm weather season, the fireplace may
emit a slight odour for a few hours. This is caused by dust
particles in the heat exchanger burning off. Open a window
to sufficiently ventilate the room.
PURGE ALL GAS LINES WITH THE GLASS DOOR OF
THE FIREPLACE OPEN. ASSURE THAT A CONTINU-
OUS GAS FLOW IS AT THE BURNER BEFORE
CLOSING THE DOOR.
• Turn off all gas to the fireplace.
• Open windows.
• Do not try to light any appliance.
• Do not touch any electric switch;
do not use any phone in your building.
• Immediately call your gas supplier from a neighbour's
phone. Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire de-
partment.
WARNING:
The gas valve has an interlock device which
will not allow the pilot burner to be lit until the thermo-
couple has cooled. Allow approximately 60 seconds for
the thermocouple to cool.
When lighting and re-lighting, the gas knob cannot be
turned from pilot to off unless the knob is
depressed
slightly.
1.
Stop! Read the above safety information on this label.
2.
Turn off all electric power to the fireplace.
3.
Turn the gas knob clockwise
to off.
4.
Wait five (5) minutes to clear out any gas. If you smell
gas including near the floor. Stop! Follow "B" in the
above safety information on this label. If you don't smell
gas go the next step.
5.
Turn gas knob counter-clockwise
to pilot.
6.
Depress slightly and hold gas knob while lighting the
pilot with the push button ignitor. Keep knob depressed
for one minute, then release. If pilot does not con tinue
to burn, repeat steps 3 through 5.
7.
With pilot lit, depress and turn gas knob counter-clock
wise
to on.
8.
If equipped with remote on-off switch/thermostat, main
burner may not come on when you turn valve to on.
Remote switch must be in the on position to ignite
burner.
9.
Turn on all electric power to the fireplace.
1.
Turn off all electric power to the fireplace if service is to
be performed.
2.
For a complete shut-down procedure: push in gas con-
trol knob slightly and turn clockwise
to off. Do not
force.
3.
For a temporary shut-down procedure: set thermostat
to lowest setting or remote switch to off. Press and turn
the gas knob clockwise
to pilot.
OPERATION / MAINTENANCE
OPERATING INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE LIGHTING:
LIGHTING INSTRUCTIONS
TO TURN OFF GAS
WHAT TO DO IF YOU SMELL GAS
FIGURE 55
FIGURE 56
Содержание StarFire GD70NT-S
Страница 28: ...28 W415 0434 C 03 24 05 NOTES...
