Napoleon Patioflame, Руководство пользователя

Страница: 13 / 40

13
EN
www.napoleon.com www.napoleon.com N415-0546 MAR 09.20 N415-0546 MAR 09.20
Burner:
The burner is made from stainless steel, but extreme heat and a corrosive environment can cause
surface corrosion to occur. This can be removed with a brass wire brush. Inspect the burner at least
annually for cracks, insect nests, excessive corrosion or any other damage. If the burner is damaged, it
must be replaced with a burner specified by the manufacturer before the appliance is put into operation.
CAUTION!
Beware of Spiders.
Spiders and insects are attracted to the smell of propane. The burner is equipped with an insect screen
on the air shutter, which reduces the likelihood of insects building nests inside the burner but does not
entirely eliminate the problem. A nest or web can cause the burner to burn with a soft yellow or orange
flame or cause a fire (flashback) at the air shutter underneath the control panel. Other warning signs that
may indicate a problem are:
• Strong or unusual odor coming from the appliance.
• Continued difficulty or delayed ignition.
• Flame appears either very short or very long.
• Flame only burns part way across the burner.
• Excessive soot building up on the lava rocks.
To clean the inside of the burner, it must be removed from the appliance: Remove the lava rocks and
examine the burner. If dirty, clean with a wire brush.
Cleaning: Use a flexible venturi tube brush to clean the inside of the burner. Shake any loose debris from
the burner through the gas inlet. Check the burner ports and valve orifices for blockages. Burner ports can
close over time due to debris and corrosion; use an opened paperclip or a drill bit to clean them. The ports
are easier to clean if the burner is removed from the appliance, but it can also be done with the burner
installed.
WARNING!
Lava rocks may have sharp or rough edges, wear safety glasses and gloves when
handling. Do not change or substitute the lava rock material provided with this appliance. If replacing,
use only replacement rocks vailable from your local authorized dealer / distributor.
WARNING!
To avoid the possibility of burns, maintenance should be done only when the
appliance is off. Avoid unprotected contact with hot surfaces. Ensure burner is turned off. Turn gas off
at source and disconnect the appliance before servicing. Clean the appliance in an area where cleaning
solutions will not harm decks, lawns, or patios. Do not use flammable, corrosive or abrasive cleaners.
Note
: Stainless steel tends to oxidize or stain in the presence of chlorides and sulfides, particularly in
coastal areas and other harsh environments, such as the warm, highly humid atmosphere around pools
and hot tubs. These stains could be perceived as rust, but can be easily removed or prevented. To provide
stain prevention and removal, wash all stainless steel and chrome surfaces every 3-4 weeks or as often as
required with fresh water and/or stainless steel cleaner.
Control Panel : The control panel text is printed directly on the stainless steel and with proper maintenance
will remain dark and legible. To clean the panel, use only warm soapy water. Never apply abrasive cleaners
on any stainless surfaces, especially the printed portion of the control panel or the printing will gradually
rub off.
Maintenance / Cleaning Instructions
WARNING!
Hose: Check for abrasions, melting, cuts, and cracks in the hose. If any of these
conditions exist, do not use the appliance. Have the part replaced by your Napoleon dealer or qualified
gas installer.
Cleaning Inside The Appliance : While washing your appliance, be sure to keep the area around the burner
and pilot assembly dry at all times.
WARNING!
If the gas control is exposed to water in any way, DO NOT try to use the appliance.
The gas control must be replaced.
!
!
!