34
W415-1539 / A / 04.19.16
ENEN
!
WARNING
5.6
INSTALLING NON-COMBUSTIBLE BOARD
NOTE:
Install the non-combustible board supplied onto the appliance pre-determined holes and align as
illustrated above secure into position using the screws supplied.
Joint Compound where required
Joint compounds such as Durabond 90 and tapes that are resilient to heat and cracking should be used when
taping and mudding seams.
Setting tiles and grouting
We recommend you use tiles with a dry butt joint to be installed using a two-part mortar with an acrylic latex
additive, such as Mapei Kerabond/Kerlastic, to allow for slight movement in the normal operation of the
appliance.
If grout is used between the tiles, a polymer-based grout, such as Mapei Ultracolour plus, is recommended.
Primer/Paint
For a painted surface, use a 100% acrylic latex primer and fi nish coat. Light coloured paints may discolour.
DO N
OT
USE S
CR
EWS
IN
THIS
LO
CA
TION
S
HI
TH
O
L
S
THE SURFACE ABOVE THE APPLIANCE GETS VERY HOT. IF PROPER FINISHING MATERIALS ARE
NOT USED, CRACKING CAN OCCUR.
NOTE: The 26 9/16" (675mm) above and the 7" (178mm) on either side of the appliance opening must
not be fi nished with any combustible materials.
Place the side non-combustible panels against
appliance and secure in place with the drywall
screws provided. The panels have pre-drilled
holes that align to pre-punched holes in the
appliance. Repeat for other side.
Place the front non-combustible panel against
appliance and secure in place with the drywall screws
provided. The piece of trim must be installed between
the non-combustible panel and the appliance. The
panel has pre-drilled holes that align to pre-punched
holes in the appliance. Repeat for other side.
Install the metal framing to the
top of the appliance, refer to
the “FRAMING” section.
