EN
W415-1427 / C / 06.05.19
25
installation
3.2.3 installing natural vent
ADAPTER INSTALLATION:
•
Remove the spill switch bracket from the rear of the
adapter.
•
Gently pull the two wire terminals (located inside the
7" (178mm) fl ue collar at the top of the appliance) out
approximately 8" (203mm).
•
Bring the wires through the lower hole in the adapter and
out the spill switch opening. To pass the wires through
the hole more easily, temporarily take the two terminals
together.
•
With the spill switch opening aligned to the back of the
appliance, take hold of the adaptor base and push the
crimped edge into the appliance fl ue collar.
•
Connect the wire terminals to the spill switch and resecure
the bracket.
For aesthetics, the adaptor has been designed to accept a
standard matte black 7" (178mm) appliance pipe and a decorative
black band (standard with the GS150KT). Both are available from
your local authorized dealer / distributor.
SWITCH
SPILL
ADAPTER
Refer to "door opening and closing" section prior to
proceeding to prevent damaging the appliance.
A.
Remove both burners and the log support
bracket.
B.
Remove the combustion air cover plate and its
gasket.
THE TWO SCREWS MUST BE RE-
SECURED.
C.
Undo the bracket holding the thermodisc, turn
90° as shown and reattach to the weld stud
located on the right air manifold side.
NOTE: Do not tighten the wing nut until
burner is installed; then ensure that the
thermodisc fi rmly touches the underside of
the burner tray and tighten. This enables the
blower to function properly.
D.
Secure the terminal block into place as shown
with the screw supplied.
E.
Gently pull the two white spill switch wires to take
up any slack. Feed these wires down through the
combustion air opening and back up through the
4x6 inch cut-out in the base. Connect the shorter
of the 2 wires to the terminal block.
F.
Attach the black on/off switch wire with the 3/16" tab
to the other side of the terminal block. Connect the
remaining wires (1 black - 1 white) with 1/4" connectors
to TP/TH and TH on the gas valve.
G.
Replace and re-secure the log support bracket and
the two burners ensuring that each venturi fi ts over the
burner orifi ce.
3.2.4 natural vent adaptations
TURBO
VIEWING
COMBUSTION AIR
COVER PLATE
MIRROR
REAR BURNER
FRONT BURNER
LOG SUPPORT BRACKETS
