22
WS-415-091 / 06.26.00
DOOR, LOUVRE AND TRIM REMOVAL
& INSTALLATION
Ensure that the
door is properly
clipped onto the
steel lip to pre-
vent overheat-
ing, glass break-
age and / or dis-
colouration of
the upper trim.
VERTICAL END TRIM
Corner and Peninsula Units only:
The two vertical end trims are each held on with a magnet,
centred on each corner post. Insert the trim under the top
facing and align along the corner posts with the bottoms of
each end trim level with the bottom of the unit.
DOOR TRIM:
Hang the side door trim onto each door
side with the notches towards the centre of the unit. The
top and bottom door trim may be installed next. Attach
magnets to the top and bottom door trim approximately 4"
from either end. Lift up the top trim and hook over the top of
the door. The bottom trim is inserted into the bottom door
sill. Push in to engage the magnets. Centre both side trims.
Side door trim is not required for the end door.
OPTIONAL LOUVRES:
The louvres are installed as il-
lustrated in
FIGURES 42.
Optional plated door trim is also
available at your local Napoleon / Wolf Steel dealer.
LOUVRE BRACKETS AND DOOR INSTALLATION:
Attach all louvre brackets as required with louvre securing
tabs facing out.
Do not attach optional louvres at this
time.
To install the door(s), hook it over the rail located
above the door opening and secure with screws along the
sides and bottom of the door. Tighten screws snugly.
Do
not over-tighten.
FIGURES 42
FIGURES 41
FIGURE 40
DOOR
STEEL LIP
