Napoleon Castlemore GDS26N, Инструкция по установке и эксплуатации

Страница: 33 / 108

W415-1333 / 06.25.14
33
EN
6.3 LOG PLACEMENT
!
WARNING
FAILURE TO POSITION THE LOGS IN ACCORDANCE WITH THESE DIAGRAMS OR FAILURE TO USE
ONLY LOGS SPECIFICALLY APPROVED WITH THIS APPLIANCE MAY RESULT IN PROPERTY
DAMAGE OR PERSONAL INJURY.
LOGS MUST BE PLACED IN THEIR EXACT LOCATION IN THE APPLIANCE. DO NOT MODIFY THE
PROPER LOG POSITIONS, SINCE APPLIANCE MAY NOT FUNCTION PROPERLY AND DELAYED
IGNITION MAY OCCUR.
THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.
76.1A
A.
Place the rear log as shown, ensuring the
holes on the underside are placed onto the
two pins of the log support.
In order to assemble the log set, the glass door must be removed, see "GLASS DOOR INSTALLATION AND
REMOVAL"section.
BRACKET
B.
Place the left log as shown, ensuring the hole
on the underside is placed onto the burner pin.
This will rest on the left side of the rear log.
6.2 DOOR GLASS REPLACEMENT
A.
Place the door frame face down careful not to
scratch the paint.
B.
Center the gasketed glass inside the door frame
with the thick side of the gasket facing up.
C.
Bend the glass retainers located along the edge
of the door frame over the gasket holding the
glass in place. Careful not to break the glass.
!
WARNING
DO NOT USE SUBSTITUTE MATERIALS.
GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.
CARE MUST BE TAKEN WHEN REMOVING AND DISPOSING OF ANY BROKEN DOOR GLASS OR
DAMAGED COMPONENTS. BE SURE TO VACUUM UP ANY BROKEN GLASS FROM INSIDE THE
APPLIANCE BEFORE OPERATION.
DO NOT STRIKE, SLAM OR SCRATCH GLASS. DO NOT OPERATE APPLIANCE WITH GLASS
REMOVED, CRACKED, BROKEN OR SCRATCHED.
56.1A
GLASS
GASKET
DOOR
FRAME
GLASS
RETAINER
C.
Place the center log as shown, follow
contour of burner and ensure port holes are
not covered.
D.
Place the hole in the underside of the right
log onto the locating pin, on the burner base
and rests against the rear log as shown.
E.
Re-install the glass door.