NAPCO X 255 -, Инструкция по программированию

Страница: 58 / 72

X
GEM-X255 Programming Instructions
L
NAPCO Security Systems
Page 58
WI1092E 10/05
ACCESSING USER PROGRAM MODE
1. Press
EEEEEE
R
2. Press
Q
Until “
ACTIVATE PROGRAM Y/N
” appears on LCD screen.
3. Press
P
To Enter User Program Mode
4. Press
C
To Exit User Program Mode when finished
New Panel (Default User Code = 123)
Existing Panel (Any Code with User Program Option Enabled)
USER CODES
Up to 195 User Codes may be programmed.
NOTE: In this mode, only the code is pro-
grammable; the accompanying Area Options
must be programmed in the Dealer Program
Mode. By default, User 1 is enabled in Area 1
and 2; Users 2-8 are enabled in Area 1, Users
9-16 are enabled in Area 2; Users 17-195 are
not enabled in any areas (see page 10).
Use the
R
button to place the cursor
over the User Number.
Enter a User Number (001–195) using the number buttons. The cursor will then advance to the User Code and read the exist-
ing code, if any.
Enter the new User Code using the number buttons (0-9). If an old code is displayed, program over it. To erase the digit at the
cursor, press
G 0
button.
Press the
U
button to save the code in memory.
Repeat this procedure for each user. To proceed to Zone-Description programming, press the NEXT button or the PRIOR but-
ton.
GEM-K1CA Keypad (Direct Entry)
Enter user code
U01 123
USER PROGR
A
M M
O
DE
Programming User Codes with GEM-K1CA Keypad
To Program User Codes
1. Set Cursor Position using the
R
button.
2. Enter 2-digit User Number
(001-195) directly using num-
ber buttons (0-9).
3. Enter Code (1-6 digits) directly
using number buttons (0-9).
4. Press the
U
button to save
each code.
NOTE: Press
G 0
button to clear character at cursor.
To continue press
P
or
Q
button.
G E M I N I
E n t e r u s e r c o d e
U 0 1 1 2 3 - -
ARM
ED
COMPUTER IZED SE CU RITY SYS TE M
STA
TUS
R 1 2 3
B 4 5 6
C 7 8 9 0
U
NEXT/YES
P
PRIOR/NO
Q
AREA
G
User Code
NOT USED