Arming With Zones Bypassed
Your alarm specialist may have pro-
grammed one or more zones for Selective By-
pass, that is, they may be removable from the
system. Since a bypassed zone cannot cause
an alarm, you may wish to use this feature to
turn off the interior areas while armed and
keep your perimeter zones (windows, doors,
etc.) active.
Press the bypass button (Key [S]), then the
number of the zone you wish to bypass.
Check the green STATUS light to be sure that
no zone is in trouble, then enter your arming
code to arm.
To verify which zones have been bypassed,
hold down Key [2] until all zones have been
displayed.
Bypassing Interior Zones
Your installer may have also selected all in-
terior zones to be Group Bypass Zones (not
for UL installations). Bypass these zones all at
the same time by simply pressing Key [S]
twice. The yellow BYPASS light will come on
whenever you bypass one or more zones. En-
ter your code to arm remaining zones; the
green light will go off and the red
ARMED/ALARM light will come on. The yellow
light will go off the next time you disarm, indi-
cating that the bypassed zones are no longer
bypassed. (The BYPASS light does not come
on when zones are auto-bypassed (unless pro-
grammed otherwise by your alarm specialist.)
To review which zones have been bypassed,
hold down Key [2] until all bypassed zones
have been displayed.
Arming With Instant Protection
Holding down Key [4] (until beep sounds)
will cancel the entry delay on the exit/entry
zones when arming. The red ARMED/ALARM
light will flash rapidly to indicate this condi-
tion. If someone enters through an Exit/Entry
Zone, an alarm will sound immediately.
Panic Alarm
(Keypad Panic Disabled?
YES
NO)
To activate a Panic Alarm, press Keys [*]
and [# ] at the same time. This feature may
have been programmed to send a silent alarm
to a central station, activate an audible alarm,
or both.
PROTECTING YOURSELF WHILE ON THE PREMISES
11
