NAPCO Gemini GEM-X255, Руководство по установке

Страница: 16 / 68

X
GEM-X255 Installation Instructions
L
NAPCO Security Systems
WI1093C 3/04
!
Page 16
BASIC ZONE CONFIGURATION
The basic zone configuration for the GEM-X255 is 8 zones. Connect as shown above to terminals 16-27. Normally
Closed (N.C.) devices may be wired in series or Normally Open (N.O.) devices may be wired in parallel. Use the 2.2K
Ohm end-of-line (E.O.L.) resistor in each zone, if selected in programming (refer to the GEM-X255 Programming Instruc-
tions WI1092). Zones 1-8 can be selected for a “Fast Loop Response (20 ms or 50 ms)” or a “Normal Loop Response
(750 ms)”. Other zone options include Entry/Exit, Interior, 24 Hour Protection, Trouble, Fire, Instant, Chime, Area Selec-
tion and Relay Output selection.
RESET OUTPUT
Reset Output can be activated depending on the programming options selected (see GEM-
X255 Programming Instructions). Connect the device controlled by the programmable output
between terminal 15 (+) and terminal 14 (-).
15
RESET
OUTPUT
EXPANDED ZONE CONFIGURATION
The GEM-X255 Control Panel may be expanded up to 255 zones. This may be accomplished by adding 88 zones to the
basic 8 zone configuration. Hardwired zone expanders include: GEM-EZM4 (4 additional zones per module), GEM-
EZM8 (8 additional zones per module) and GEM-RP1CAe2/GEM-K1CA Keypad (4 additional zones per keypad). Wire-
less zone expanders include: GEM-RECV8 (8 additional zones per receiver), GEM-RECV16 (16 additional zones per re-
ceiver), GEM-RECV96 (96 additional zones per receiver) and GEM-RECV255 (247 additional zones per receiver). Wire-
less transmitters include: GEM-TRANS2, GEM-KEYF, GEM-SMK, GEM-PIR, GEM-DT and GEM-GB.
Additional Zones are numbered 9-96.
R
COMPUTERIZED SECURITY SYSTEM
GEMINI
A R
M E
D S T
A T U
S
SYSTEM ARMED
01/01/97 12:00AM
1 2
4 3
5 6
7 8 9 0
A
B
C
D
E
F
G
NEX T/YES
PR IO R /NO
AREA
GEM-RP1CAe2
(2 LINE LCD KEYPAD)
W
IRI
NG
C
O
N
N
E
C
TI
ON
S
GEM-RECV-8
GEM-RECV-16
GEM-RECV-96
GEM-RECV-255