DTW38FL, DTW12FL
7
Rev. 01/23/13
NOTE:
When using the wrench in "
ANGLE"
mode the wrench
must be
placed flat (horizontally) on table or workbench before any
attempt is made to change values or to power up the unit.
If the user attempts these functions without following the instructions above the unit's display will begin to flash a series of
four zeros in the top half of the screen.
In order to reset the unit, remove the battery cover; then replace.
IMPORTANT!
LOW BATTERY VOLTAGE PROTECTION
Battery Indicator
SLEEP MODE
• The wrench will automatically go into "Sleep" mode after
being idle for approximately 2 minutes to save power.
Press
to wake from "Sleep" mode.
• If the battery voltage is below 2.3 volts, the wrench
will highlight the battery symbol and after a few
moments turn off.
Angle Mode Warning
SELECTING UNITS OF MEASURE
The torque wrench displays 4 different
units of measure plus angle:
1. Newton meters (N-m)
2. Inch Pounds (in-lb)
3. Foot Pounds (ft-lb)
4. Kilogram Centimeter (kg-cm)
5. Angle
Pressing the button allows you to
cycle sequentially though each of these units of
measure and the angle display.
N-m
In-lb
Ft-lb
Kg-cm
Angle
ft.-lb.