• 3 •
7. FOLLOW THESE STEPS WHEN BATTERY IS OUTSIDE VEHICLE
WARNING: A SPARK NEAR THE BATTERY MAY CAUSE A BATTERY EXPLOSION.
TO REDUCE THE RISK OF A SPARK NEAR THE BATTERY:
7.1
Check polarity of battery posts. POSITIVE (POS, P, +) battery post usually has a larger diameter than
NEGATIVE (NEG, N, –) post.
7.2
Attach at least a 24-inch-long 6-gauge (AWG) insulated battery cable to NEGATIVE (NEG, N, –) battery post.
7.3
Connect POSITIVE (RED) charger clip to POSITIVE (POS, P, +) post of battery.
7.4
Position yourself and free end of cable as far away from battery as possible – then connect NEGATIVE
(BLACK) charger clip to free end of cable.
7.5
Do not face battery when making final connection.
7.6
When disconnecting charger, always do so in reverse sequence of connecting procedure and break first
connection while as far away from battery as practical.
7.7
A marine (boat) battery must be removed and charged on shore. To charge it on board requires
equipment specially designed for marine use.
8. GROUNDING AND AC POWER CORD CONNECTIONS
8.1
This battery charger is for use on a nominal 120 volt circuit and has a grounded plug. The charger must be
grounded, to reduce the risk of electric shock. The plug must be plugged into an outlet that is properly installed
and grounded in accordance with all local codes and ordinances. The plug pins must fit the receptacle (outlet).
Do not use with an ungrounded system.
8.2
DANGER: Never alter the AC cord or plug provided – if it does not fit the outlet, have a proper grounded
outlet installed by a qualified electrician. An improper connection can result in a risk of an electric shock
or electrocution.
NOTE: Pursuant to Canadian Regulations, use of an adapter plug is not allowed in Canada. Use of an
adapter plug in the United States is not recommended and should not be used.
8.3
USING AN EXTENSION CORD
The use of an extension cord is not recommended. If you must use an extension cord, follow these guidelines:
• Pins on plug of extension cord must be the same number, size, and shape as those of plug on charger.
• Ensure that the extension cord is properly wired and in good electrical condition.
• Wire size must be large enough for the AC ampere rating of charger, as specified:
Length of cord (feet)
25
50
100 150
AWG* size of cord
16
12
10
8
*AWG-American Wire Gauge
9. ASSEMBLY INSTRUCTIONS
9.1
It is important to fully asssemble your charger before use. Remove all cord wraps and uncoil the cables
prior to using the battery charger. Follow these instructions for assembly.
PARTS
TOOLS NEEDED
(1) Wheels assembly
(4) 1/4-20 x 3/4˝ screws
Flat head screwdriver
(not included)
9.2
Attach the feet: Remove the charger from the packing
materials and place back down on a flat surface.
Attach the feet and secure them with the four
1/4-20 x 3/4˝ screws provided. Attach wheels to axle.
9.3
Extend the handle from the retracted position
by pulling it upward until it locks into place.
(Press the small silver buttons inward, if necessary.)
