NanoCam Plus NCP-DVRGPSWIFI, Руководство пользователя

Страница: 39 / 48

39
To set up Motion Detection on your Dash Cam follow the directions below.
1. Press the
OK
(Rec/Ok) Button to stop the Car DVR from recording.
2. Press the Button 4 times to enter the General Setting Menu.
3. Use the Up and Down Buttons to navigate the Settings Menu and highlight the Protect
Level setting and press OK (Rec/ Ok) to select.
4. Use the Up and Down Buttons to highlight either OFF/ LOW/ MIDDLE/ HIGH, then press
the OK (Rec/Ok) button to confirm your selection.
NOTE:
1. Menus cannot be accessed while the camera is recording. Please stop the recording before
attempting to access the menu.
22.2 SETUP RESET
Setup Reset will make the camera go back to default factory settings
1. Press the
OK
(Rec/Ok) Button to stop the Car DVR from recording.
2. Press the Button 4 times to enter the General Setting Menu.
3. Use the Up and Down Buttons to navigate the Settings Menu and highlight the Setup
Reset setting and press
OK
(Rec/Ok) to select.
4. Select Yes or No to restore to default factory settings .