WWW.NANLUX.COM
21
2.2. DMX Terminator
ln DMX control mode, the DMX output of the last fixture should be connected with a DMX terminator (Not included). This prevents interference caused by DMX
signals in the transmitting process. The terminator is connected with a 120Ω(OHM) resistor across Pin 2 and Pin 3. (As shown below)
2.3. ADDRESS Setting.
2.4. Refer to the DMX reference guide from www.nanlux.com and control the light via DMX/RDM console.
(For specific operation methods, please refer to the DMX/RDM console operation manual.)
2.5. Note: For technical data, please download from https://www.nanlux.com/en/h-col-274.html.
3. RDM Control
3.1. Connect the light fixture to the console with RDM function, the connecting method is the same as that of DMX console.
3.2. ontrol the fixture via a console with RDM function. (For specific operation instruction, please refer to the RDM console operation manual.)
Note: The UID format of the fixture is as follows:
DMX Terminator Connection
Connect a 120Ω(OHM) resistor
across Pin 2 and Pin 3 in an
XLR plug and insert into the
DMX OUT socket on the last unit.
PIN 2 PIN 3
120Ω
1
2
3
5
4
0008
XXXX
XXXX
Serial number
801
：
Evoke 900C
Manufacturer: Nanguang
