NAMCO Scooter, Руководство по эксплуатации

Страница: 9 / 51

CHAPTER 2: MACHINE MAINTENANCE
The Scooter ™
The extractor is engineered and designed to require minimum maintenance. But like any
machine, it does require some care to keep it in optimum working condition. Careful attention to
these maintenance instructions will give you maximum operating performance and increase the
life of your machine.
CAUTION: Disconnect power cord from the outlet before doing any maintenance
work on the machine.
Flush machine and accessories after each use or at least once a
day with clean water.
1. SOLUTION FILTER SCREEN
Outside attached to the Solution Hose there is a filter screen that
serves as a filter to prevent dirt or debris from getting into the pump.
Clean as needed.
2. VACUUM FILTER
Always keep the filter clean in order to maintain maximum suction
and airflow performance from the vacuum motors. The filter also
prevents lint from accumulating in the fan chamber thus increasing
the productive life of the motor. DO NOT operate the machine
without the filter installed! If the filter gets dirty or damage, replace
immediately.
3. VACUUM MOTORS
Brush mechanisms (carbon brush, spring and holder) should be
replaced after 500 hours or when the carbon brushes are worn down.
Both brushes should be replaced at the same time. If there is
excessive sparking have vacuum motors checked immediately to
prevent possible electrical shock or damage to motors. Also check
bearings for excessive play on fan. If any play replace the motor
immediately. NOTE: Avoid overflowing of the recovery tank.
Damage could result from excessive water in vacuum motors.
4. ELECTRICAL
Inspect for any wires with frayed insulation. Check for loose connections and/or corroded terminals.
Check wire nuts for tightness. Check plug end for bent or loose prongs and if necessary replace with
approved plug. Unit must always be grounded or electrical shock could occur.
1
3