NAMCO Scooter, Руководство по эксплуатации

Страница: 20 / 51

CHAPTER 5: SPECIAL CLEANING
The Scooter ™
APPLICATIONS & PROCEDURES
o
NAMCO Carpet Blower/Dryers & Dehumidifiers are available for quick drying
of carpets.
o
To speed up the drying time of carpets that have just been cleaned, the air-mover
(3-speed/2500 CFM) variable speed may be placed on the carpet during the cleaning
process. Avoid walking on the carpet until it is dry. This blower can also be used
for flooded carpets. NOTE; Wet-VAC all excess water out of the carpet first with the
Scooter and then pull up one corner of the carpet and insert the carpet dryer under
the carpet. This will move air up and under carpet and possibly dry the padding
without removal.
2. TO CLEAN HARD FLOOR SURFACES
The use of our optional Squeegee Wand Assembly gives the extractor the versatility of
being in cleaning and sanitizing hard floor surfaces. This Squeegee wand has a tremendous
advantage over the use of a string mop in that you can use it to rinse dirt, grease, stubborn
spots, food, etc… and all the dirty solution is vacuumed up and rinsed with clean water at the
same time leaving the floor practically dry. This Squeegee wand is designed to clean most
commercial kitchen floors, tile floors, and linoleum floors without the need or use of a mop.
3. TO USE THE SQUEEGEE WAND
1.
Sweep and remove all debris from surface being cleaned.
2.
Spray with recommended tool the proper floor cleaning solution.
3.
Connect squeegee rinse wand in the same manner as regular carpet floor wand and
thoroughly rinse and vacuum up entire surface.
4. TO CLEAN UPHOLSTERY
Cleaning upholstery with success requires a good knowledge of the type of fabric to be worked
on. Look for the cleaning instructions label sewn on the underside of the furniture for the
recommended method of cleaning the fabric. If it calls for dry-cleaning, DO NOT attempt to
clean with the wet extraction method. Otherwise, damage to the fabric could occur. The
extraction method is effective on most synthetic, wool and cotton fabrics.
Before proceeding, always test the fabric to be worked on for colorfastness. Pour a small amount
of cleaning solution on to a white terry towel and apply to an inconspicuous spot. Apply pressure
for approximately 30 seconds and then check towel for any color transfer. If any color comes off,
or transfers DO NOT continue.
1.
Attach vacuum hose end to upholstery tool and solution connecting coupler to the tool;
make sure the couplers have been connected properly.
14