CHAPTER 1: SAFETY INSTRUCTIONS
The Scooter
™
1. WHEN THE MACHINE IS DELIVERED
Check the carton and machine carefully for signs of rough handling. Remove the machine from
the carton.
IF THE MACHINE IS DAMAGED, NOTIFY THE CARRIER IMMEDIATELY AND
REQUEST AN INSPECTION.
Be sure to keep the carton, packing list, packing inserts and carrier’s
receipt until the inspector has verified your claim. Manufacturer’s liability ceases when carrier
picks up the machine or shipment.
2. BEFORE OPERATING THE MACHINE
Read the Manual carefully and completely before attempting to operate the unit. This Manual has
important information for the use and safe operation of the machine. Keep this manual handy at all
times.
3. GENERAL PRECAUTIONS
1.
Make sure the machine is plugged into an electrical outlet with the same voltage as shown on
the switch plate of the machine. DO NOT attempt to plug a 115-volt machine into a 220-volt
outlet.
2.
Disconnect power cord from the outlet before attempting maintenance or repair work.
DO NOT
leave machine connected to an electrical outlet when unattended.
3.
DO NOT
abuse power cord. Never pull the machine by the cord or yank the plug from the
receptacle. The machine is operated on a wet carpet and a potential shock hazard can result
from a damaged cord. Replace a damaged cord immediately.
4.
DO NOT
operate machine in standing water. Such use can cause electrical shock.
5.
DO NOT
use volatile substances such as gasoline or kerosene in the machine or on or near
the surface to be cleaned. The use of such materials could cause an explosion and fire.
6.
If an extension cord is necessary, use a three conductor grounded cord 12 gauge wire or
heavier to prevent motor burnout and over heating of wire.
7.
To avoid electric shock,
DO NOT
expose to rain - store indoors.
4. GROUNDING INSTRUCTIONS
To protect the operator from electrical shock, the machine is factory equipped with an approved
three-conductor cord and grounding plug
.
(figure A - see page 2)
This plug is to be used only with proper grounding type receptacles.
The machine has a plug like the one shown in figure A. An adapter
(figure B & C - see page 2)
is
available for connecting three prong type plugs to two prong receptacles. The green rigid lug
extending from the adapter must be connected to a permanent grounding such as a properly
grounded outlet box. DO NOT break off or pull out the grounding blade.
1
Содержание Scooter
