NAMCO Ridge Racer 2, Руководство оператора

Страница: 18 / 22

Page
7-4 Removing the Shield Case
1. Perform Steps (1) and (2) described in Section 7-3.
2. Disconnect the connector of the AC Fan.
3. Remove two cup screw (M5 x 14) then take out the shield case.
7-5 Removing the Power Control Panel
1 Perform steps 1, 2, 5 and 6 described in Section 7-3.
2. Disconnect two connectors of the EMI board, remove a cup screw (M4 X
10) from the shield case door, then remove the ground terminal. (Note:
do not lose the internal washer).
3. Disconnect the connectors connecting the power control panel and the
main body assy: one connector on the right side and two connectors on
the left side then remove the power control panel.
7-6 AB Pedal Assy (Replacing the Control)
1. Remove four hex head bolts (M6x20) and withdraw the assy forward .
2. Loosen the quadrant gear clamp screw and remove the quadrant gear.
3. Loosen the gear grub screw and remove the gear.
4. Replace the control potentiometer.
Note: When reassembling
a. Ensure that the potentiometer locating tag is engaged in the mounting
plate
cutout.
b. Turn the potentiometer shaft almost fully clockwise before engaging the
quadrant gear.
7-7 Gear Shift Assy (removing)
1. Remove 4off M5x20 button head screws and pull forward the play panel
assy and disconnect the four way connector on the gear shift assy.
2. Remove four M4 coach bolts and withdraw the shifter assy.
15
Re-initialize the game ( see 5-4 Page 10 "Adjusting the Game" ) whenever
the game PCB board, ROM, Steering Assy, AB Pedal Assy or Controls
are replaced before the game is played.