NAKTO Discovery, Руководство по сборке

Страница: 9 / 26

Step Four：Adjust the front brake system.
NOTICE: The The adjustment of the front brake system is not easy. The
following steps are only a general guide to assist in the adjustment of the
front brake system. Consult a certified, reputable bike mechanic to assist
with it.
The end goal is a caliper that is parallel to the rotor, with even gap
(2mm-3mm) on each side, and an adequate lever feel. Before adjusting
the front brake system, make sure the axle nuts in Step One have been
tightened.
1.Alignment procedure of the front brake.
Notice: Usually, all bike's rear brake were adjusted in the good condition
at factory. If not, alignment procedures are the same for front and rear
brakes. The end goal here is to keep 2mm-3mm clearance on either side
of the disc brake rotor so that the pads do not rub on the rotor when they
are not applied.