4
A
B
C
INSTALLATION | CELL HOUSING
INSTALLATION STEPS
(Refer to Typical System Installation diagram)
CELL HOUSING CONFIGURATION OPTIONS
Connect the Cell Housing horizontally (A or B) in the return line to the pool
(use Reducing Bushes supplied if using 40mm PVC pipe) using high pressure
PVC glue. The Cell Housing can be mounted vertically (C) but provision must
be made for a gas trap.
Check that the O-ring is clean, greased with silicone grease (DO NOT use
petroleum based jelly) and securely located in the Cell Housing.
Fit the OXI Cell and ensure the Locking Ring is firmly tightened by hand.
DO NOT USE A TOOL TO TIGHTEN
A Venturi Pipe is incorporated within the Cell Housing designed to eliminate any
possible gas build up, although it is always recommended to ensure proper
installation to eliminate this from happening.
The Cell Housing must be installed in the RETURN pipework to the pool. It must
always be installed AFTER the filter, gas heater, solar heating or heat pump.
Before you start:
VERTICAL
STEP 1
STEP 2
STEP 3
HORIZONTAL
HORIZONTAL
Indicates direction of water flow
