5
INSTALLATION | CONTROL UNIT
INSTALLATION STEPS
(Refer to Typical System Installation diagram)
Attach Wall Mounting Bracket in the desired location for Control Unit using
Wall Plugs and Mounting Screws provided.
Fasten Control Unit including Weather Shield to Wall Mounting Bracket with
locking screw provided.
Connect the OXI and ION plugs to the base of the Control Unit ensuring a
FIRM
CONNECTION.
Plug the Control Unit 3 pin plug into a suitable weatherproof RCD protected
10amp outlet and then plug the pump power cable into the 3 pin AC Socket
located at the bottom of the Control Unit.
See ‘External Controllers’ on Page 9 for setup with automation systems.
STEP 1
STEP 2
STEP 4
STEP 3
The Control Unit has an Ingress Protection Rating of IP34 enabling it to be
installed outdoors. Regulations require that the Control Unit shall be installed
outside the pool zone. The Control Unit shall be installed according to AS/NZS
3000 wiring rules.
The Control Unit should be installed in a well ventilated position, ideally away
from sunlight and rain to prolong life and at least 1m above ground to prevent
run off water entry.
Ensure that the Control Unit is not stored near chemicals, fertilisers or in a closed
unventilated shed with similar products as the fumes will cause excessive
corrosion and damage to the internals of the Control Unit and may void warranty.
When mounting the Control Unit on a post it is recommended to install a flat
panel of at least the same size or larger to act as a waterproof backing plate.
Mounting the Control Unit horizontally or leaving it on the ground will void all
warranty.
The Control Unit should be mounted no further than 1.5 metres from the Cell
Housing for ease of operation.
The pump rating must NOT exceed 8 Amps.
Before you start:
