Nakayama SM9800, Руководство пользователя

Страница: 6 / 43

EN
WWW.NAKAYAMATOOLS.COM
6
Description of main parts (Picture A - Page 2)
Operation
1) Do not operate the engine in a confined space where dangerous carbon monoxide fumes can collect;
2) Work only in daylight or in good artificial light;
3) Always be sure of your footing on slopes;
4) Walk, never run with the machine;
5) For wheeled rotary machines, work across the slopes, never up and down;
6) Exercise extreme caution when changing direction on slopes;
7) Do not work on excessively steep slopes;
8) Use extreme caution when reversing or pulling the machine towards you;
9) Do not change the engine governor settings or over-speed the engine;
10) Start the engine carefully according to manufacturer instructions and with feet well away from the tool(s);
11) Do not put hands or feet near or under rotating parts;
12) Never pick up or carry a machine while the engine is running;
13) Stop the engine:
- Whenever you leave the machine;
- Before refuelling;
14) Reduce the throttle setting during engine shut down and, if the engine is provided with a shut-off valve,turn the fuel off at the conclusion of working;
Maintenance and storage
1) Keep all nuts, bolts and screws tight to ensure the equipment is in safe working condition;
2) Never store the equipment with petrol in the tank inside a building where fumes can reach an poor flame or spark;
3) Allow the engine to cool before storing in any enclosure;
4) To reduce the fire hazard,keep the engine,silencer,battery compartment (not included with all models) and petrol storage area free of vegetative material
and excessive grease;
5) Replace worn or damaged parts for safety;
6) If the fuel tank has to be drained,this shall be done outdoors.
1. Handlebar
2. Reverse Handle
3. Choke Switch
4. Handrail Support Assembly
5. Tire Assembly
6. Spring Pin
7. Protective Cover
8. Fender Guard
9. Cutter Assembly
Technical data
10. Drive Seat
11. Starter Handle
12. Fuel Tank
13. Oil/Air Filter
14. Belt Pulley Cover
15. Handle Support Seat Assembly
16. Throttle Governor
17. Clutch Handle
Displacement: 196cc
Torque: 13Nm
Max. Power 6.5HP/4000rpm
Starting System: Recoil
Type of Clutch: Belt
Driving Speeds: FW 1.88-3.88km/h, BW 1.6km/h
Gears : Forward / Neutral / Backward
Fuel Volume: 3.6Lt
Fuel Type: Unleaded Gasoline (95 octane or higher)
Oil Volume: 0.6Lt
Width of Cutting: 100cm
Adjusted Height: 1-8cm
Attention! For safety
reasons, the machine
may be delivered with-
out engine oil. Please
add the appropriate
quantity of the rec-
ommended type of oil
before operation.
If the engine of the
machine is delivered
topped up with oil
please replace it with
the appropriate quantity
and recommended type
of oil before operation.