Nakayama PRO BL3600, Руководство пользователя

Страница: 5 / 18

EN
WWW.NAKAYAMATOOLS.COM
5
Fuel and oil Requirements
Use only fresh, clean fuel.
Use a special type 2-cycle oil (30ml of oil for each 1L of unleaded gasoline 95 octane).
Mixing Instructions
1. Fill an approved fuel container with half of the required amount of gasoline.
2. Add 2-stroke oil to gasoline.
3. Close container and shake to mix oil with gasoline.
4. Add remaining gasoline and remix.
5. Install fuel container cap and wipe any spilled fuel from container and surrounding area.
Handling Fuel
Warning: Fuel is VERY flammable. Use extreme care when mixing, storing or handling or serious personal injury may result.
● Use an approved fuel container. DO NOT smoke near fuel.
● Do not allow flames or sparks near fuel.
● Fuel tanks/cans may be under pressure. Always loosen fuel caps slowly allowing pressure to equalize.
● NEVER refuel a unit when the engine is HOT.
● NEVER refuel a unit with the engine running.
● Do not fill fuel tanks indoors. ALWAYS fill fuel tanks outdoors over bare ground.
● Securely tighten fuel cap after refuelling.
● Inspect for fuel leakage. If fuel leakage is found, do not start or operate unit until leakage is repaired.
Important
Spilled fuel is a leading cause of hydrocarbon emissions. Some states may require the use of automatic fuel shel-off containers to reduce fuel spillage. Contact
your dealer for ordering information.
After Refuelling
● Wipe any spilled fuel from the unit.
● Move at least 3m from refuelling location before starting.
After Use
● DO NOT store a unit with fuel in its tank. Leaks can occur.
● Return unused fuel to an approved fuel storage container.
Storage
● Fuel storage laws vary by locality.
● Contact your local government for the laws affecting your area. As a precaution, store fuel in an approved, air tight container.
● Store in a well ventilated, unoccupied building, away from sparks and flames. Do not store fuel longer than 30 days.
Important
● Stored fuel ages. Do not mix more fuel than you expect to use in thirty days, ninety days when a fuel stabilizer is added.
● Stored two-stroke fuel may separate. ALWAYS shake fuel container thoroughly before each use.
● Check that blower pipe is not blocked by the ground or by any objects.
Warning: Do not operate this product indoors or in inadequately ventilated areas. Engine exhaust contains poisonous emissions and can cause serious injury
or death.
Keep A Firm Grip
Hold handle with fingers together encircling the handle.
Keep A Solid Stance
Maintain footing and balance at all times. Do not stand on slippery, uneven or unstable surfaces. Do not work in odd positions or on ladders. Do not perform
Maintenance or Assembly procedures with engine running.
Noise Control
Follow local noise regulations on sound levels and hours of operations. Use only during appropriate hours. Never use a higher speed setting then necessary to
perform a task. The higher the engine speed the louder the blower noise. Be a good neighbour.
Avoid Hot Surfaces
During operation, the muffler or catalytic muffler and surrounding cover may become extremely hot. Avoid contact during and immediately after operation.
Always keep exhaust area clear of flammable debris. Allow the engine and muffler to completely cool before performing any maintenance activity.
Specific rules for blower/vacuums
1. Do not use the machine to pick up humid material, water, liquids, pieces of glass,iron,stones or tin cans,this could be very dangerous for you and the machine.
2. Do not use the machine to pick up hot embers or material which is burning or smoking. Do not use the machine to pick up lit cigarettes. Do not use the
machine to pick up material which has been contaminated by flammable or explosive materials. Do not suck in highly flammable fumes. Always check that the
material picked up by your machine is not flammable, toxic or explosive.
3. Do not use the vacuum mode without the dust bag in place.
4. Always keep the area to be cleaned free from wires,stones,debris,tin cans and other obstacles.
5. Avoid colliding with hard objects which could damage your machine.
6. Keep bystanders and animals at least 5m away from the working area.
7. Avoid colliding with hard objects which could damage your machine.
8. Do not manually insert objects into the blower/vacuum tube.