Nakanishi Sheenus neo, Руководство по эксплуатации

Страница: 15 / 18

29
Problem Item to be checked Possible cause Countermeasure
Not vibrate.
DISPLAY
⑧
not light
up.
The Plug of Power Cord is not
inserted. Insert the plug of Power Cord.
The Main Power Switch
④
is OFF. Turn on the Main Power Switch
④
..
The Power Cord is broken. Replace the Power Cord.
The Main Power Switch
④
is
defective.
Return to a NAKANISHI dealer
for service.
The fuse is blown.
Replace the fuse. If the replaced
fuse is blown again, contact
your local Nakanishi dealer.
ON LED does not
light up GREEN.
The ON / OFF Switch ⑥ is OFF. Turn ON the ON / OFF Switch ⑥ .
The plug of Handpiece is not
p r o p e r l y c o n n e c t e d t o t h e
R e c e p t a c l e f o r C o n n e c t i n g
Handpiece
⑩
.
Connect the plug of Handpiece
properly.
The Foot Switch ③ is defective.
Return to a NAKANISHI dealer
for service. The output cord is broken.
ON LED lights up
GREEN. The ultrasonic oscillator or the
Control Unit
①
is defective.
Vibration stops
during operation. RESET LED lights up
RED.
To o m u c h p r e s s u r e o n t h e
tool and the protection system
activated. Do not put too much pressure
on the tool.
The Power Control Knob
⑨
is set
too high.
Adjust the Power Control Knob
⑨ to a lower setting and restart.
T h e t h e r m a l p r o t e c t o r i s
activated when in continuous
operation. Tu r n O F F t h e M a i n P o w e r
Switch
④ and the system to cool
down.
The tool has become loose. Re-tighten the tool.
The tool is broken or bent. Replace or straighten the tool.
Vibration is low.
O N L E D l i g h t s u p
GREEN.
Non-standard tool is used. Replace the tool.
The tool is not tightened properly. Tighten the tool.
The Power Control Knob ⑨ is set
too low.
Adjust the output power to the
optimum level for the work.
CLAMP mode ( ) is set.
Change the setting to
UNCLAMP mode (
).
Abnormal noise or
sudden heat rise is
generated. ON LED or RESET
LED lights up.
The tool has become loose. Clamp the tool.
The tool is broken or bent. Replace the tool.
Non-standard tool is used. Replace the tool.
13. TROUBLESHOOTING
If a problem or concern occurs, please check the following prior to consulting your dealer.