40
6
Setup
Various settings can be made for your use from below.
6 – 1
User setting operations
1
Set the Main power switch to OFF.
2
While holding down the ON / OFF key (1), turn on the
Main power switch (2).
Press the UP key (3) during the 2 seconds when "
" is displayed.
With a "beep" sound, "
"*1 will appear on the
display.
①
③
②
3
Press the UP key to select the item you want to set.
The display unit will display the following order*2: "
"
Ѝ
"
"
Ѝ
"
"
Ѝ
"
"
Ѝ
"
"
Ѝ
"
"
Ѝ
... When the settings are
complete, turn the power off and then on again to
complete the settings.
6-2 Setting the forced stop time
when not in use
6-5 Setting the foot switch
6-3 Setting of notification volume
6-6 Setting the handpiece heat
protection function
6-4 Setting the amplitude display
and WATT Display
NOTICE
Ɣ
Memory function
When the power is turned off and then on again, the settings before the power was turned off are retained. (For
mode settings, return to CLAMP mode (low output).
Ɣ
Pressing the foot switch does not activate the controller during the 6 – 1 User setting operations.
*
1 "
" is displayed only when it is first set up.
After the second time, "
", "
", "
", "
", "
",
"
", or "oA", which are stored by the "memory
function", will be displayed.
*
2 Display order
"
"
Ѝ
"
"
Ѝ
"
"
Ѝ
"
"
Ѝ
"
"
Ѝ
"
"
Ѝ
...
is displayed only at the initial
setting.From the second time onwards, the settings are
retained by the "memory function".
B6KHHQXV=(52B(1BLQGG