22
Do not rotate the machining centers' main spindle while the Brushless Motor Spindle is
installed. Rotating the machining centers' main spindle with the Brushless Motor Spindle
installed can cause the Motor Cord to become tangled, pulling the CONTROLLER off its
mounting and cause severe damage to the motor cable and its connections. This will lead
to a severe injury.
DANGER
①
Installing the Brushless Motor Spindle should be performed by a person with
experience with machining center operation and compressed air plumbing.
②
This Brushless Motor Spindle is not a hand tool. It is designed to be used install this
Brushless Motor Spindle to the machining center's machines or milling machine
machines.
③
Do not touch the cutting tool while it is running. It is very dangerous.
④
Wear safety glasses, dust mask, and use a protective cover around the Brushless
Motor Spindle whenever the Brushless Motor Spindle is rotating.
⑤
Never connect, disconnect or touch the Power Cord Plug or Motor Cord Plug with wet
hands. This may cause an electric shock.
⑥
Never operate or handle the Brushless Motor Spindle until you have thoroughly read
the Operation Manuals and safe operation has been confirmed.
1) To prevent injuries / damages, check the Brushless Motor Spindle and cutting tool
for proper installation, before operating the Brushless Motor Spindle.
2) Before disconnecting the Brushless Motor Spindle, always turn the control power
off and turn the compressed air supply to the CONTROLLER off. Then it is safe to
remove the Brushless Motor Spindle.
⑦
When installing a Brushless Motor Spindle to a fixed base, make sure the fixed base is
grounded in order to avoid the risk of an electric shock.
⑧
When installing a tool, tighten the collet correctly and check again the collet and collet
nut before use. Do not over-tighten the collet. This may cause damage to the spindle.
⑨
Do not use bent, broken, chipped, out of round or sub-standard tools, as this may
cause them to shatter or explode. Tools with fractures or a bent shank will cause injury
to the operator. When using a new tool, rotate it in a low speed and increase speed
gradually for safety.
⑩
Do not exceed the maximum recommended allowable tool speed. For your safety, use
speeds below the maximum allowable speed.
⑪
Do not apply excessive force. This may cause tool slippage, tool damage, injury to the
operator or loss of concentricity and precision.
WARNING
①
Do not drop or hit this Brushless Motor Spindle, as shock can damage to the internal
components.
②
Be sure to clean the collet and collet nut, the inside of the spindle before replacing
the tool. If ground particles or metal chips stick to the inside of spindle or the collet,
damage to the collet or spindle can occur due to the loss of precision.
CAUTION
OM-K0587 002_HES810_(A5x18)_EN_150205.indd 22
2015/02/05 17:24:43
