Nakanishi HES810, Руководство по эксплуатации

Страница: 14 / 22

EN
G
LIS
H
33
④ Insert the
φ
4mm air hose to the Air Joint on the side face of the Brushless Motor Spindle
(Fig. 16).
⑤ Remove the Electrical Protective Cap of the Motor Cord and keep it for use when not using the
Motor / Spindle to keep the connector pins safe and clean.
⑥ Carefully insert the Alignment Pin on the Motor / Spindle into the Alignment Hole on the Motor
Cord, then push the connector straight into the Electrical Connection of the Motor / Spindle
(Fig. 17).
⑦
Tighten the Connector Nut of the Motor Cord in a clockwise direction (Fig. 16).
Fig. 16
Insert
Tighten
Air Joint
Motor Cord
Connector Nut
φ
4mm
Air Hose
Plug
Motor Cord Side
Alignment
Hole
Alignment
Pin
Brushless Motor
Spindle Side
Fig. 17
①
Insert and Clamp the Brushless Motor Spindle
into the machining center's main spindle.
②
Remove the Electrical Plug Cap from
the Brushless Motor Spindle by turning it
counterclockwise (Fig. 15).
③ Carefully remove the Air Plug from the
Brushless Motor Spindle's Air Joint by pressing
in the Release Bush in the quick disconnect
while pulling on the end of the Air Plug
(Fig. 15).
Electrical Plug Cap
Air Joint
Loosen
Release Bush
Air Plug
Pull
Push
Fig. 15
OM-K0587 002_HES810_(A5x18)_EN_150205.indd 33 2015/02/05 17:24:49