7
・
Before connecting to the Motor Cord to the Brushless Motor Spindle and CONTROLLER, verify
the Main Power Switch on the CONTROLLER is turned OFF. If the Main Power Switch on the
CONTROLLER is ON while connecting the Motor Cord, damage to the CONTROLLER is possible.
・
Install the Protective Cap etc. to prevent damage or contamination to the Motor Cord Plug when
not in use.
CAUTION
①
Remove the Protective Cap of the Motor Cord.
Connector
Alignment Pin
Alignment Hole
Connector
Motor Cord Side
Brushless Motor Spindle Side
Take Out
Protective Cap
Insert
Take Out
Push
Tighten
Brushless Motor Spindle Side
Motor Cord Side
Connector Nut
②
Carefully insert the alignment pin into the alignment hole and push straight into the Connector of the Motor Cord.
⑤
Insert the provided air hose.
④
Remove the protective air inlet Quick Disconnect
Cover.
③
Tighten the Connector Nut with clockwise.
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
When installing a Brushless Motor Spindle to a xed base, make sure the xed base is grounded in
order to avoid the risk of an electric shock.
WARNING
CONNECTION OF MOTOR CORD
9.
INSTALLATION OF THE BRUSHLESS MOTOR SPINDLE
10.
