Setting the Clock
Setting the Clock Manually
1.
2.
3.
4.
5.
6.
7.
•
•
•
In standby mode, press and hold the clock button (
CLOCK
) on your remote control, the
LCD will display CLOCK SET and CLOCK 24 begins to blink.
Set the 12/24 hour format with the
VOL-
and
VOL+
button.
Press the clock button (
CLOCK
), hour indicator will blink.
Set the hour with the
VOL-
or
VOL+
button.
Press the clock button (
CLOCK
), minute indicator will blink.
Set the minute with the
VOL-
or
VOL+
button.
Press the clock button (
CLOCK
), the built-in clock starts operating.
Setting the Clock Automatically
Tune into a RDS FM station, press and hold the DISPLAY button. The clock will automatically
update.
Display the Clock
In any source mode, the built-in clock shows the time on the display by pressing the CLOCK
button on your remote control.
Please Note:
To exit clock setting mode without storing, press the stop button ( )
If no button is pressed for 90 seconds, the unit exits clock setting mode automatically.
If a power failure occurs or the unit is disconnected from the mains, the clock setting will
be lost.
16
When the RDS station display the time, press and hold the
DISPLAY
button on the remote
control, the clock will automatically sync time of RDS.
This receiver allows you to use Radio Data System (RDS), which enables FM radio stations to
send additional information (e.g. time) along with the regular programming signal.
Not all FM stations provide RDS service, nor do they provide the same type of services. If you
are not familiar RDS services in your area, check with your local radio stations for details.
