Page | 38
7.2.1.
RUNNING MODE INTERACTION TABLE
The following table lists all the interactivity that is possible with the saber while in running mode. If the One Button
is enabled in the config, please see the interaction guide for one button below.
Entry
Label
Action
Description
Aux Button
AUX +/-
Press
Pressing the aux button engages Blaster Block mode. Once in
this mode, swinging the saber will perform EzBlaster™, where
another Blaster Block will be performed. Keeping the saber
still will cause the mode to exit.
Aux Button
AUX +/-
Hold
Holding the aux button engages the Lockup effect. Depending
on the chosen config setting, either releasing the button or
tapping it again will cause the mode to exit.
Aux Button
AUX +/-
Press (in
Clash)
Pressing the AUX button will perform EzLockup™;
immediately after the press the Lockup sound will play when
in Clash mode.
Aux
Clash
AUX +/-
Hold + Clash
Pressing and holding the AUX button and performing the
clash motion will perform the EzLockup™, skipping the clash
sound and going right to the lockup with the clash color.
Swing saber
NA
NA
Swinging the saber causes a single swing sound to be played.
If the swing is performed rapidly then a Slash sound will be
performed.
Hit saber/Blade CS
NA
Hitting the saber against something or hitting your hand on
the hilt will cause the Clash sound to play. To return to
running simply wait for the clash to finish.
Main Button
MAIN+/-
Hold/Unlatch Holding or unlatching the main button will cause the
retraction sound to play and then the saber will return to Idle
mode.
Table 4 – Interactions possible when the saber is running, and two buttons are installed.
7.2.2.
RUNNING INTERACTION FOR ONE BUTTON
If the saber is configured to run with one button, the following is the interaction guide while operating the saber:
Entry
Label
Action
Description
Main Button
MAIN +/-
Press
Pressing the aux button engages Blaster Block mode. Once in
this mode, swinging the saber will perform EzBlaster™, where
another Blaster Block will be performed. Keeping the saber
still will cause the mode to exit.
Main Button
AUX +/-
Press (in
Clash)
Pressing the AUX button will perform EzClash™; immediately
after the press the Lockup sound will play when in Clash
mode.
Swing saber
NA
NA
Swinging the saber causes a single swing sound to be played.
If the swing is performed rapidly then a Slash sound will be
performed.
Hit saber/Blade CS
NA
Hitting the saber against something or hitting your hand on
the hilt will cause the Clash sound to play. To return to
running simply wait for the clash to finish.
