6
Nagra -
CLASSIC DAC
Powering the CLASSIC DAC
The CLASSIC DAC can be powered either by its own internal power supply or by an
ex12V(+12.6V)
with the Nagra MPS or the CLASSIC PSU. In the first case,
simply use the AC Mains cable provided.
Connecting the Mains
Place the Mains power switch on the rear panel of the unit
in the OFF position, marked «0».
Insert the C13 IEC connector of the power cable into the
C14 IEC Appliance inlet of the CLASSIC DAC.
You may then push the Mains switch into the «I» position.
Fuse replacement
The fuse holder includes a replacement fuse.
The fuse type is: FST 5x20mm 250V / T 500mA L.
Should you need to replace it, use only the same
fuse type and value.
Should the fuse blow more than once, please
contact your Nagra dealer for assistance.
Connecting the Nagra Power Supply
Start by removing the power cable from the C14
IEC Appliance inlet of the CLASSIC DAC. The
Mains switch position is no longer relevant when
an external power supply is connected.
Place the front rotary selector in the OFF
position. Insert the LEMO connector from the
external power supply cable into the DC socket
as shown beside. You will hear a click that
indicates the connector is securely locked.
Please note that the LEMO plug features a red
dot that must be facing upwards for a correct
insertion into the DC power input socket.
The BLACK-sleeved LEMO plug should be connected to the CLASSIC PSU or the
BLACK-sleeved LEMO plug with the additional BLACK ring to the Nagra MPS.
To disconnect the LEMO plug, hold the fluted
section of the connector, and pull it backwards.
C13 IEC
connector
