Nagel 2S Trimmer, Руководство пользователя

Страница: 12 / 30

© Ernst Nagel GmbH 9965242 User Manual 2S Trimmer en.doc Rev.1.0. 16.11.2010
12
4. Operating the 2S Trimmer (continued)
4.5 Job Setup
Fig. 1 Fig. 2
Fig. 3 Fig. 4
Step Action Remarks
1. Job Setup Press the ‘Jobs’ button two times (Fig. 1& 2).
2A. Make a new Job Press the ‘New’ button (Fig. 3).
2A. Enter Job name
Use the ‘
+ / -
‘ and ‘ ► ’ buttons (Fig. 4) to Enter the Job
name and press the ‘Enter’ button.
Attention: An “Loading Job” signal appears for a
few seconds.
2B. Adjust a Job Use the ‘ ▲ / ▼ ’ buttons to select a Job and press the
‘Enter’ button to load or confirm.
Attention: An “Loading Job” signal appears for a
few seconds.
3. Adjust Input Size and/or Side
Trim
Use the ‘ ▲ / ▼ ’ and the ‘
+ / -
‘ buttons to set the
desired settings for Input Size and Side Trim
(See Chapter:
4.6 Paper Input Size Setup
4.7 Side Trim ON/OFF
4. Save Job After adjusting press ‘Jobs’ (Fig. 1) and save the current
Job or ‘Rename’ the adjusted Job by pressing the
‘Enter’ button (Fig. 2).
Attention: An “Saving Job” signal appears for a
few seconds.
Attention: After Rename a Job, repeat step 2A
‘Enter Job name’.