8
DT Series - Installation manual (V4_2022)
2.
GENERAL INFORMATION
2.1.
INTRODUCTION
This manual has been made to simplify the installation, maintenance, and the operation of this
equipment. The strict application of these instructions will ensure the conformity of the
installation to
Nagas Innovation’s
recommendations.
The application of the instructions given in this manual is one of the conditions of the
warranty, however it does not guarantee at any time conformity with the applicable laws,
rules, codes, and regulations of the country of destination of the equipment installed.
This manual is protected under international copyright laws. No part of this manual may be
reproduced, distributed, translated, or transmitted in any form or by any means, electronic or
mechanical, including photocopying, recording, or storing in any information storage and
retrieval system, without the prior written permission of
Nagas Innovation
.
2.2.
LISTED PRODUCT
This equipment has been declared to conform to applicable Canadian and American standards
(CSA 2.6 and ANSI Z83.8) and bear the cETLus marking.
This equipment is intended for industrial or commercial use only. The installation must comply
with the latest laws and regulation for gas heating units CSA B149.1 / ANSI Z223.1 / NFPA-54,
to the electrical code CSA22.1 / NFPA-70 and to local laws, rules, and regulations. All the
electrical installation located inside or outside of this equipment must comply with the unit’s
electrical diagrams.
The electrical and ratings described on the rating plate appear on the unit. Following these
ratings is mandatory for a safe use of the unit. To learn more, read this manual carefully.
2.3.
RESPONSIBILITY
This equipment must be used expressly for the purpose for which
Nagas Innovation
has
designed and manufactured it. Any contractual liability of
Nagas Innovation
is therefore
excluded in case of injury to persons, animals or damage caused to goods, following errors in
installation, settings, maintenance, or inappropriate use.
Nagas Innovation
is responsible for the conformity of the device to the codes and standards of
construction in force at the time of sale. Knowledge and respect for the legal provisions as well
as the standards inherent in the design, implantation, installation, commissioning, or
maintenance are exclusively the responsibility of the installer or integrator.
Be advised that this manual does not cover all possibilities, situations, or eventualities. Regular
service is necessary to ensure proper and safe operation of this equipment. If you have any
doubts about performing these tasks yourself, you should hire a qualified specialist.
