•
Bring the fiber tubes to the splice tray from the left
side, when viewed from the top, and arrange them
side by side so that the outermost is the first tube and
the innermost is the last tube.
•
Fasten the tubes with cable ties.
•
If the fiber tubes of MLT cable are brought to the
splice tray, cut the tubes at approximately 25 mm
from the mounting point and clean the fibers from
the gel.
•
If you are using Naficon's universal splice trays, rotate
the fiber bundles for the two upper splice protection
sleeves by using the whole splice tray and take them
from the left side to the splice protection sleeves.
•
The bundles to the lower two splice protection
sleeves are first rotated from the middle of the tray to
the other side of the tray, then around the whole tray
and finally from the right side to the splice protection sleeves.
•
The splice tray cover is inserted and marked with the necessary markings.
3.5
Placement of splice trays mounted on the splice tray holder
•
Pull the cable into the cabinet enough to leave the cable jacket outside the cabinet.
•
Temporarily attach the cable to the mounting points on the back of the cabinet.
•
Place the splice tray in the splice tray holder in the correct position, waiting for the outdoor
cable fibers to be spliced to the tail cables.
•
Guide the fiber tubes under the splice trays from the hinge side of the rotating frame to the
back of the cabinet. Take care of the bend radius of the tubes so that they will not be
damaged.
•
Important notes in the arrangement of fiber tubes:
➢
Bend radius of the fibers
➢
The trajectory of the rotating frame
➢
removing the splice trays from the splice tray holder one by one