Nady Systems ALD-800, Руководство пользователя

Страница: 4 / 12

4
Confirming Correct Installation
The transmitter’s
TX leD (6)
will flash
when a microphone or line level signal is
broadcast by the transmitter. If “TX” does
not flash, turn the audio input gain control
clockwise. This will increase audio level
and cause “TX” to flash along with the
program source. When “TX” is flashing,
the transmit ter is broadcasting properly.
Test the trans mit ter with an ALD-800
receiver. This pro ce dure is explained in
the receiver instructions.
Note: For the best performance, and to minimize
the possibility of interference from another source,
we suggest you experiment to find the minimal
height the antenna must be extended in order to
perform well in your particular environment.
Channel selection
Channel selection is controlled by
DIP-switches inside the trans mit ter.
The system is preset at the factory.
Changing the channel can be done
quickly by any qualified service tech ni cian.
Contact your dealer or the Nady Customer
Service Department for details.
using More Than One alD-800 system
You may operate up to three ALD-800
systems in the same location. For multiple
system operation, please observe:
If operating two ALD-800 transmitters in •
the same location, use Ch. AA and HH
(or GG).
If operating three ALD-800 transmitters
•
in the same location, use Ch. AA, EE
and HH (or GG).
Locate the transmitters ten feet or more
away from the performers wearing
ALD-800 receivers.
alD-800 Transmitter (Front Panel)
alD-800 Transmitter (rear Panel)
7
4
6
5 8 1
2 3