FIRST TIME USE
Out of the box and connecting the VISO 1 AP to the mains power source for
the first time, the “
S
” indicator will alternately switch to green and red light
after initializing. This indicates that the VISO 1 AP is ready to be configured.
Refer to the following sections to fully enjoy and appreciate your VISO 1 AP.
SETTING UP NETWORK CONNECTION
AirPlay lets you stream music from your AirPlay-enabled device to the VISO
1 AP. The AirPlay-enabled device and the VISO 1 AP must be in the same
network to send and receive streaming audio with AirPlay.
The VISO 1 AP can be connected to a network using any of the following
methods
A
Wired connection
B
Wireless connection
C
Share Wi-Fi setting
Start playback of your device after successful network connection using any
of the above methods.
WIRED CONNECTION
Network connection using Ethernet broadband connection. Set up a Wired
Ethernet broadband router with broadband internet connection. Your
router or home network should have a built-in DHCP server to consummate
the connection.
•
Using a standard straight-through Ethernet cable, connect one end of
the Ethernet cable (not supplied) to the LAN port of your wired Ethernet
broadband router and the other end to VISO 1 AP’s LAN port.
•
The ”
S
” indicator will turn to solid green upon successful network
connection.
It is advisable that wired connection is utilized when possible. Wired
connection is less likely to have “drop-out” or range problem and not
vulnerable to interference or eavesdropping.
WIRELESS CONNECTION
Wireless (WiFi) broadband router with broadband internet connection is
required for wireless connection to be established. Wireless connection for
VISO 1 AP can be setup by the following procedure.
1
Press and hold “
S
” until it turns flashing green – this indicates it is in
Access point/setup mode already.
2
Using your iOS device (iPad is used here for reference), select among
the list of available network connections the unique network ID (
NAD_
VISO1_DF601A
in this example) of your VISO 1 AP.
3
Launch Safari and enter
http://192.168.1.12
. The
VISO 1 AP User
Interface
menu window will appear. Select
Profile Configuration
.
4
Select your local network from the drop down
SSID
list (
NADLAB
(WPA2 TKIP+CCMP
) in this example).
NOTES
• The
Status Information
displays current details about your VISO 1 AP
like connection status, signal strength, firmware version and others. If
your VISO 1 is configured already, locate and access the TCP/IP address
of your VISO 1 AP to check
Status Information
.
• Firmware Update is not for consumer use- this is restricted to authorized
NAD service personnel and distributors.
5
Type the
WPA Passphrase
(if it is password protected) of your local
network in the field provided and then select
Apply
to join in.
VISO 1 AP OPERATION
7
ENGLISH
FR
ANÇ
AIS
ESP
AÑOL
IT
ALIANO
DEUT
SCH
NEDERL
ANDS
SVENSK
A
РУ
ССКИЙ
