27
REMOTE CONTROL UNIT
FACTORY RESET
The HTR L76 can be reset to its factory state, deleting all learned commands, copied and punched through
keys, macros, and other set-up information, reverting all keys to their pre-programmed library commands.
To perform a factory reset simultaneously press-and-hold for 10 seconds the HTR L76's "ON" and "RTN"
keys; the Learn LED will start to flash green. Release "ON" and "RTN" before the second flash is complete;
the Learn LED will turn red, indicate the remote has been reset.
NOTE
You must release "ON" and "RTN" before the second flash goes out, otherwise the unit will not reset;
should this occur, repeat the full procedure.
DELETE MODE
The HTR L76 can store learned, copied, and "default library" commands on any single key. (The default
library commands are the pre-programmed NAD codes, such as the native L76 commands on the "AMP"
"page.") You can delete commands by layers back "down" to the default library command on any key,
removing learned commands, punched-through functions, and copied keys.
NOTE
The default library commands cannot be deleted, so you need not worry that using Delete Mode
might cause irreparable changes.
To enter Delete Mode, simultaneously press-and-hold for 3 seconds both the desired key's Device Selector
key and the "RTN" key, until the Learn LED turns green. Press the function key whose command you wish
to delete; the Learn LED flashes; the number of times indicates which type of function has become active
see the table below. Press the active Device Selector key again to exit Delete Mode.
NOTE
You may delete multiple function-key commands on the same Device Selector "page," but to delete
from more than one Device Selector page you must exit Delete Mode and then re-enter it on the
required page.
Flashes
Command Type
1
Default Library Command
2
Copied Library Command
3
Learned Command
ENGLISH
FRANÇAIS
DEUTSCH
NEDERLANDS
ESP
AÑOL
IT
ALIANO
POR
TUGUÊS
SVENSKA
