13
Brush overload.
The brush LED light will flash if the brush motor has been
overloaded (Fig.28).
Releasing the handle triggers will allow the machine to stop
and reset.
If the brush motor keeps overloading consider using a different type of brush.
Or move the transit wheels to obtain different brush pressures,
Heavy brush load decreases the available battery run time.
Setting the cleaning controls
Hi / Lo speed can only be toggled when the machine is in
STAND-BY MODE.
Water On / Off can only be toggled when in ACTIVE MODE.
Brush / Vac Switch
can be cycled in both
STAND-BY and ACTIVE MODE.
Fig.28
To activate the machine from SLEEP MODE press either trigger
once.
Fig.27
When the triggers are released the brush motor and the cleaning solution pump will switch off, the vacuum motor will
continue for 10 seconds (this is to clear any fluid residue in the hose).
The panel if unused will automatically enter SLEEP MODE after 60 seconds.
The ETB has been fitted with a Hi - Lo mode, this reduces the noise produced by the
vacuum motor by 3dB.
To operate the Hi - Lo mode start the machine in the normal way.
When the machine is running normally the Hi Lo light will be illuminated blue, this means the
Vacuum motor is running at 100%.
With the machine running press the Hi Lo button once the Vacuum motor will reduce speed
to 75% of capacity and the Hi lo light will not illuminate.
STAND-BY
Stage 1.
Brush and Vac
Stage 2.
Brush only
Stage 3.
Vac only
ACTIVE
Stage 1.
Brush and Vac
Stage 2.
Brush
