26
Cap
Inner clamp
Battery case
Lithium battery
・Connecting the adjusting unit, perform reset.
・Confirm proper resetting by hearing the motor operating sound. With
proper resetting, the motor will stop in a short time.
Note: If the motor does not stop, perform reset again. (There is a risk that
battery electricity may be abnormally consumed.)
Fig. 22 Removing the Battery Cap
Fig. 23 Removing the Battery
4
Turning the cap on the battery case using a coin, remove the battery.
(Figs. 22 and 23).
5
Insert a new battery into the battery case.
Note: When inserting a battery, align the battery wire with the slit of an
inner clamp. [If the battery is placed in the reverse side, the
battery can not be inserted fully (Fig. 23).]
6
Putting back the cap on the battery case, fix it properly.
7
Install the inner clamp on the frame.
Note: When installing the inner clamp, place the battery connector on
the upper surface of the circuit board as shown in Fig. 21.
8
Set the retaining screw.
9
Insert the battery connector into the circuit board connecter (Fig. 20).
CAUTION
Tighten the screw until its head reaches slightly below the frame surface and
insert the outer clamp. Overtightening may press the battery case and
damage the battery.
CAUTION
