N-Tron 7506GX2 Series, Руководство пользователя и инструкция по установке

Страница: 94 / 158

(Revised 2011-07-21)
Page 94 of 158
N-Link – Configuration, Continued…
Complex N-Link Configuration (Example):
N-Ring #1
N-Ring AM
N-Link Slave
#1
N-Ring AM
N-Link Master
#1
Partner
Link #1
Control
Link #1
N-Rng
Manager
N-Link AC
N-Ring AM
N-Link AC
N-Ring AM
N-Ring
Auto
Member
Primary
Coupler
Link #1
Standby
Coupler
Link #1
N-Ring #2
N-Ring
Auto
Member
N-Ring AM
N-Link Slave
#2
N-Ring AM
N-Link Master
#2
Partner
Link #2
Control
Link #2
N-Rng
Manager
N-Link AC
N-Ring AM
N-Link AC
N-Ring AM
N-Ring
Auto
Member
Primary
Coupler
Link #2
Standby
Coupler
Link #2
N-Ring #3
N-Ring
Auto
Member
N-Ring AM
N-Link Slave
#3
N-Ring AM
N-Link Master
#3
Partner
Link#3
Control
Link #3
N-Rng
Manager
N-Link AC
N-Ring AM
N-Link AC
N-Ring AM
N-Ring
Auto
Member
Primary
Coupler
Link #3
Standby
Coupler
Link #3
N-Ring #4
N-Ring
Auto
Member
N-Ring
Auto
Member
N-Ring
Auto
Member
N-Rng
Manager
Configuration Notes:

The Master and Slave must be part of the N-Ring topology.

If using default configuration choices, the administrator only needs to configure the N-Link Master.
The N-Link Slave and both Coupler switches will auto-detect any needed configuration.

If not using default configuration choices, the administrator may also need to configure the Default
Coupler port on the N-Link Slave.

There must be a direct link between the Master and Slave Control ports. Use of media converters or
other switches is not supported.

There must be a direct link between the Master and Slave Partner ports. Use of media converters or
other switches is not supported.

There must be at least one other switch, besides the Master and Slave, that supports N-Link on the
N-Ring. If there are multiple Master/Slave devices on the same N-Ring, then there must be one N-
Link aware, but non-participant, between each Master/Slave pair on the N-Ring.

N-Link will only support a single point of failure. Multiple points of failure and misconfiguration
are not supported and may cause a network storm under some circumstances.
Configuration Steps to redundantly couple 2 N-Ring networks:
1. Ensure the Coupler and Control cables are disconnected at this point.
2. Get Both N-Rings working with a status of OK.
3. Configure N-Link Slave: Ensure that the N-Link Slave is set to Auto Configure and select a Default
Coupler Port. Save Configuration.
4. Configure N-Link Master: Select the Control and Coupler ports. Save the Configuration.
5.
Connect the Control Link cable. Ensure that the Slave switch status now shows a state of ―Slave‖
6. Connect the Coupler Link cables.
7. Check N-Link status by selecting the N-Link Status View page.