MZ electronic EV030-Radio, Инструкция по эксплуатации

Страница: 18 / 76

EV030-Radio Rev. 08
– 2019
English
18
Installing the magnet on the anchor windlass
•
A hole having a diameter of 6.5 mm (~
1/4”) and depth of 8 mm (5/16”) must be drilled on a tooth
of the gipsy, in a place outside the chain’s path.
•
In the case of vertical shaft anchor windlasses (see Fig. 1B), drill the hole in the lower
circumference of the gipsy.
•
In the case of horizontal shaft anchor windlasses (see Fig. 2B), drill the hole in the outer
circumference of the gipsy.
•
Also make sure that the protruding part of the magnet will not collide with the base or sensor
during rotation of the gipsy.
•
Insert the metal part of the magnet in the hole, allowing the protected part to protrude by about 2
mm. Fix it in place using an adhesive for metals (two-component epoxy glue) or silicone. The
glue used must be able to withstand a marine environment.
Installing the magnetic sensor for vertical shaft anchor windlasses
(see Fig. 1A
– 1B
)
•
Apply the drill template (see appended instructions) and drill a 4 mm
(~3/1
6”) hole in the cover through which to thread the sensor cable.
•
Fasten Part A of the support with the two screws provided, after
having positioned the O-ring in the lower part of the support.
•
Fit Part B with the magnetic sensor on support A and adjust its
height until it is aligned with the magnet fastened on the gipsy.
•
Bring the sensor to a distance of about 3 mm (
~1/8”) from the
magnet and secure it in place by tightening screw G1. Then tighten
screw G2.
Installing the magnetic sensor for horizontal shaft anchor
windlasses
(see Fig. 2A
– 2B – 2C
)
•
Apply the drill template (see appended instructions) and drill a 4 mm (~
3/16”)
hole in the cover through which to thread the sensor cable.
•
Fasten Part A of the support with the two screws provided, after having
positioned the O-ring in the lower part of the support.
•
Cut Part C to measure using a hacksaw. The sensor must be positioned at a
distance of about 3 mm (
~1/8”) from the magnet.
•
Fit Part C with the magnetic sensor on support A and fix it in place using an
adhesive for plastic (two-component epoxy glue) or silicone.
•
Using the same glue, attach the sensor to Part C.
Installing the chain counter
(see connection diagram)
C
A
OR
OR
A
B G1
G2