E N G LI S H F R A N Ç A I S
Caring for
Your MYX
MAINTENANCE
Preventative maintenance can extend the
life of your product and significantly reduce
equipment failures. The chart provided is
our recommended maintenance schedule. It
is your responsibility to ensure that regular
maintenance is performed.
Worn or damaged parts must
be replaced immediately, and should not
be used until the repair is made.
CH ECKLIST
WE E KLY MONTH LY
Inspect for loose nuts or bolts on handlebar and
seat assembly and tighten as necessary.
x
Tighten pedals upon delivery and every 100 hours
thereafter: MYX I—Verify that pedal shafts and
pedal bolts securing the pedal shafts to the back of
the bike cranks are tight. Re-tighten as tight as you
can get them with an open end wrench or pedal
wrench. MYX II—Verify that the threaded pedals
are tightly secured in bike crank. Re-tighten as
tight as you can get them with an open end wrench
or pedal wrench.
x
Inspect pedals for excessive wobble or side-to-side
movement. If loose, they need to be replaced.
x
Tighten seat hardware (bolt connecting seat
to post)
x
Lubricate horizontal and vertical sliders (for seat
and handlebars) with dry film lubricant with PTFE
or wet film lubricant with PTFE. Apply a layer and
use a cloth to clean up excess.
x
Inspect welds for any signs of cracking
x
Inspect leveling feet
x
Check for rust and remove any minor buildup
found using a small brush.
x
Inspect the seat for wear and tear. Rips, tears,
or excessive movement indicate the seat needs
to be replaced.
x
Inspect pedal toe clips and straps for any
looseness or excessive wear. Replace if toe
clips cannot be tightened to pedal or if the
strap shows excessive wear.
x
CLE ANING
We recommend wiping down and cleaning
the product frame daily. For a deeper clean
use water with a non-abrasive soap, car
wash soap, or bike cleaner. Wipe with water
and dry. Avoid spraying any liquids directly
onto the product. Instead, spray onto a clean
towel first then wipe the product. You may
also seal the frame with wax or bike polish.