2014 Mytrix Technology
All rights reserved Third Version
34
3. Enable retraction: retract the filament when print.
Effect:
Without retraction, it will over pull the filament which will impact the overall
printing.
4. Bottom/top thickness: the thickness of the bottom and the top.
Effect:
If the printed model has damaged holes on the top, please adjust the thickness
figure accordingly.
5. Fill rate: 0 for hollow, 100 for solid.
Effect:
It can save print time by decreasing the filling, but will impact the print strength.
Hollow might lead to failure of completing the print model because the wall is too thin.
Therefore appropriate filling is necessary.
6. Print speed: recommend 40-60mm/s.
Effect:
Slow down the speed appropriately, allow reasonable cooling time while
printing, the model will be printed out better.
7. Printing temperature: the nozzle temperature while printing, ABS recommend 210-
230, PLA recommend 190-220.
Effect:
Too low temperature makes extrusion stopping, and it will block the nozzle to
export filament.
8. Bed temperature: ABS recommend 90-110
℃
, PLA recommend 70-80
℃.
Effect:
If the temperature is too low and the filament is not adhesive enough, edge warp
might happen.
9. Support type: because there will be overhang during printing, the filament might drop
Содержание Dreamweaver
