4. Fill container with coating material. Screw firmly onto spray gun.
5. Place the spray gun in the spray gun holder.
6. Only place the device on an even and clean surface.
7. Before connecting to the mains ensure that the mains voltage
corresponds with the details on the rating plate and the power switch
on the unit is switched OFF.
8. Remove the spray gun from the spray gun holder and point at object to
be sprayed. Turn on using ON/OFF switch on the device.
9. Adjust the spraying pattern and amount of material; set the amount of
air and pressure, see fig.8,9,10.
10. Press the trigger on the spray gun.
Note:
When the device is switched on, air will continually flow from the air cap -
this is normal.
Adjusting for the required spray effect:
With the union nut (3) turn the air cap (1) to the required spray pattern.
www.hygienesuppliesdirect.com
Fig. 9
Fig. 10
11
MYESG01_Paint_sprayer_Manual 22/12/16 08:56 Page 11
