2 cm
pic
.O
pic
.P
pic
.Q
pic
.R
pic
.S
•
Put the gate to CLOSING position.
•
Unlock the operator (refer to section 4 Manual Operation).
•
Extend the inox arm fully.
•
Turn back the arm 2 cms. This avoids the motor to “leap forward” (picture O).
Press the plastic cap with little force, and gently slide it forward (picture P).
Insert the bracket in the motor and fit the pin (picture Q).
•
Mount the arm of the motor onto the gate. Ensure the arm is perfectly straight. Check the manual opening of
the leaf before definitively fixing the bracket to make sure the gate can open fully to your required angle.
•
If the bracket position is the correct one, remove the pin (picture S) and proceed to definitively fix it.
•
Repeat steps shown in picture
Q
and
R
.
3.4.5. FIXING THE GATE BRACKET
Follow the below procedure to determine the bracket position on the gate:
9
rev01_22
