Page 6 , in 12 pages
3.2 Water infusing:
3.2.1 pull out the plug of the water inlet hole
，
insert the water funnel
3.2.2 infuse water till water spill out from the spillway hole.
3.3 Checking
3.3.1 Make sure there is no water leaking;
3.3.2 Make sure there is no moisture or wet for electricity connecting parts;
3.3.3 Make sure the key switch is in the off position;
3.3.4 Make sure the emergency stop switch is in the on position.
3.4 Starting the equipment
3.4.1 Connect the power cord, turn on the key switch;
3.4.2 Double confirm there is no leaking of water circulation, fold the protective cover by
turning it right.
3.5. Debugging
3.5.1. Make sure water and electric circuit is correct connected; then turn on the power to
start the machine.
3.5.2. Turn on the master power switch on the backboard;
3.5.3.Turn on the emergency switch (clockwise turn) in the front side of the mainframe
3.5.4. Turn on the key switch (clockwise turn);
3.5.5. Check is there any leaking of the water connectors.
3.5.6. If the above is checked OK, put the wire cover into the neck on the backboard then
turn deasil to get fixed.
3.6. Operation
Enter operation condition after debugging and no abnormalities found.
3.6.1. Treatment Selecting Interface
