MyBinding Plockmatic BM 200, Руководство по установке, Страница: 17 / 53

1-12
31 January 2007
1.3.4 CONNECTORS
1. If a collator is present, connect the communication cable [A] from the collator
(
x1), to the Booklet Maker.
2. Connect the Belt Stacker cable [B] (
x1).
NOTE: Unless Trimmer FTR 200 and/or SquareFolder SQF 200 will be installed.
If so, Belt Stacker cable will be connected to the last module in the system.
3. Install the Terminator plug [C] and the Interlock jumper [G].
NOTE: The Terminators and Interlock jumpers are stored in the installation kit.
4. Install the Terminator plug [D] and the Interlock jumper [F].
NOTE: Unless Trimmer FTR 200 will be installed. If so, communication cable
and power cord between BM 200 and FTR 200 will be connected.
5. Connect the powercord [E] to the Booklet Maker (
x1).
6. Mount the cable protector [H] positioned as shown with two screws in the
holes [I] and route the cables inside the cable protector (
x 2).
7. Attach the sticker “Do not lift here” [J] on the cable protector.
8. Install the cable holders [K] on the rear side of the Booklet Maker base and
route the cables through them.
BOOKLET MAKER INSTALLATION
[H]
[J]
[B] [A] [C] [D] [E] [F] [G]
Only Booklet Maker installed
[I]
[K]
Cable protector mounted Cable holder mounted on Booklet Maker