seTTIng The CubeX pRInT JeT offseTs
CauTIon:
Do not use the offset menu unless you have been advised to do so by Cubify support, as changes to
this may affect the quality of multi-material prints .
!
PRINTING THE CALIBRATION FILE
Download the CubeX calibration file from (enter address here)
Print the CubeX calibration file as you would any other print file.
ReaDInG THe CaLIbRaTIOn fILe
The lines on the calibration print are offset by 0 .1 mm . The amount of
misalignment can be calculated by counting the amount scale 2 or 3 is
offset
from
scale
1 .
scale 1 is printed by Print Jet 1 . This is the reference print jet . all offsets are
relative
to
Jet
1 .
scale 2 is printed by Print Jet 2 . This error amount is the amount Print Jet 2
needs its offsets to be adjusted .
scale 3 is printed by Print Jet 3 . This error amount is the amount Print Jet 3
needs its offsets to be adjusted .
HOW TO aDJusT THe OffseTs
Touch the relative offset to activate it, a plus and a minus will appear at the
side of the screen . use this plus and minus to adjust the offset .
PRINT JET 2 Y OFFSET
Compare the lines on “Y scale 1” and “Y scale 2” to find the ones that most
accurately line up . because variation is small, it may be easiest to spot 3
that look like they all line up . If this is the case, use the middle one as the
correct
one .
Mark this line with a pen for easier identification.
On “Y scale 2” count from the center line (with the arrow) to the marked line .
If you are counting down, the scale the number is negative . If you are
counting up, the scale the number is positive .
Write
down
the
offset .
In the example shown in figure 1, the Y offset for extruder 2 is -0 .4mm .
26
