SAFETY PRECAUTIONS
All safety messages are identified by the following the words "
WARNING
" and
"CAUTION". These words mean the following:
△
WARNING
Important information to alert you to a
situation that might cause serious injury and
damage to your property if instructions are
not followed.
△
CAUTION
Important information that tells how to prevent
damage to equipment.
When using the scale/balance, the following safety precautions should always be
followed.
△
WARNING
Use only the AC adaptor with the scale/balance. Other adaptor may cause
damage. (AC adaptor is optional)
△
CAUTION
Avoid installing the scale/balance in direct sunlight, this may cause discoloration or
malfunctions.
Do not mix the type of batteries. Replace all other batteries at the same time.
If the scale/balance is not to be used for a long period of time, remove all batteries
from the battery compartment to avoid leakage which may cause damage to the
instrument.
Avoid overloading that could cause damage to the scale/balance.
Do not drop water in the scale/balance that is not water-resistant. It causes damage,
if inside of the scale/balance is wet.
Matter charged static electricity could influence the weighing. Discharge the static
electricity. As example, the method is to use the electrification prevention spray, to
spray it to both side of weighing platform.
1
SPECIFICATIONS
Model number i5500
Capacity 100g
Division 0.005g
Platter / Tray
140
×
165mm
Net/gross weight
510/620g
Standard carton: 29
×
22
×
14(cm
3
)
Package
12 Units in one box: 60
×
45
×
45(cm
3
)
Operating Temperature
0-40c (32-104
℉
))
6
×
AA Size Batteries or AC/AC
Power source
Adapter 11V/150mA (optional)
**SPECIAL WARNING**
Cell-Phones, Cordless-Phones, and any radio-frequency device can
cause temporary interference and cause the scale to temporarily not
work properly. Please do not use any electronic device near the i101.
Just like in an Airplane, do not use your cell-phone near the scale
when it is in use. While there is NO risk of permanent damage to
the scale, interference can cause an incorrect calibration or incorrect
weight readings.
FUNCTION SETTINGS
4.
Enter function setting mode.
The scale should be OFF. Press
and hold [UNIT]
first, then press and
release
[ON/OFF] (while
keeping
[UNIT]
pressed) the display will show
LIGHT
or
A_OFF
arrow and the display will show 888888 Now you can
release the UNIT key.
