My Water Filter MWF BIG BLUE WHOLE HOUSE WATER FILTRATION SYSTEMS, Инструкции по установке и уходу за изделием

Страница: 8 / 17

NOTICE:
IMPORTANT: PLEASE DO NOT OR MUST NOT use any form of sealant on
the threads of this water filter. Please ONLY use plumbers thread tape. If
you use any sealants they have a history of expanding after the water filter
is connected and can crack the inlet & outlet ports and they will start to leak
within a day or so. Please advise the plumber or installer sealants cannot be
used in any form - You can only use Thread Tape.
Maximum/Minimum Pressure
The minimum working pressure required will be determined by the cartridge
type installed inside this water filter. Sediment cartridges do not slow the
water flow generally unless blocked with sediments, but a fine micron car-
bon block cartridge can take a bit of pressure to push the water through
the cartridge. Suburban water pressure works well. The maximum working
pressure is around the 80 psi mark. If you have more pressure than 80 psi
you should install a pressure limiting valve before the water filter to ensure
no excess pressure is exerted into the system.
Installing Gauges
Please take care when installing the gauges, please apply plumbers thread
tape only to the gauge thread. Tighten taking extra care the threads have
not been crossed. Tighten gauges until tight. If any gauges threads seem
to be a tight fit simply turn the gauge forward as far as possible without to
much force, then turn the gauge back the other way to untighten, then turn
the gauge forward again until you have the gauge installed as required. DO
NOT use any form of sealants on the gauge threads.
Water Flow Direction
Please note: These water filters are set up to flow the water from left to
right. If you want the water filter to flow the other way you will be required
to remove the bracket and turn it around 180 degrees and refit the bracket
so once installed the complete water filter housing is set up correctly.